-
General Adhesive room temperature cure. Resistant to Toluene, Ethanol, Aviation Gas and Diesel Fuel. A low viscosity, two component, chemical resistant epoxy system. Post cured material has excellent resistance to most petroleum based fuels and solvents during exposure at ambient and elevated temperatures. CLR 3080 / CLH 6372
-
High Temperature. A single component, 100% solids, low viscosity, impregnating compound for coils and transformers. This product is also suitable for sand casting. CLS 9600
-
A two component polyurethane casting system. Product has long pot-life and cures to a hardness of 65 Shore D. XID 1681 / XHD 1652
-
High temperature clear epoxy. An unfilled, heat resistant, clear laminating system. Products low viscosity gives the system excellent wet-out properties to fibreglass and other reinforcing fibres. The material exhibits high physical strengths and modulus with moderate post cure temperatures. XRD 1014 / XHD 1015
-
1:1 Mix Ratio, 130°C Operating, General Purpose, Low cost. A two component, room temperature cure semi-flexible, flame retardant, epoxy system. The system was developed for potting/casting of electrical and electronic components. Its use of non-abrasive fillers and convenient 1 to 1 ratio by volume, make it ideal for use in machine dispensing equipment. This product meets UL94-V0 in house flammability testing. XRD 1018 / XHD 1019
-
Machine dispense friendly, tough, casting epoxy system. Increased flexibility when compared to CLR 1831 family. A two component, low stress, heat cure epoxy system specifically developed for use on instrument and power transformers. The product if filled with non-abrasive fillers, making the product suitable for machine dispensing. The cured material exhibits excellent thermal stability and thermal cycling endurance. Product meets UL 94-HB flammability requirements. XRD 1321 / CLH 5185